1. Anti fingerprint agent for glass manufacturers recommends to use alcohol or thinner to clean the grease, plastic film, and other stains and residues on the surface of the workpiece to be sprayed, so as to ensure that the surface of the workpiece is clean, and the electroplating surface can be directly spraying.
2. This product can be painted on the workpiece with a wool brush, but anti fingerprint agent for glass manufacturers suggest that the effect of spraying will be better and the appearance will be brighter.
3. The spraying air pressure needs to be between 0.4 and 0.8mps. Different products have different air pressures. The higher the air pressure of most products, the better. Before construction, please drain the water in the air compressor to ensure that the air supply system is dry to avoid unnecessary damage. Loss.
4. If the workpiece is too large, it is recommended to have a dust-free workshop for high-gloss mirror products with a length and width of more than 2 meters, so as to avoid unnecessary losses caused by the increase of defective products, and the company will bear the losses.
5. Anti fingerprint agent for glass manufacturers recommends that you use the correct paint number before using it. Do not mix water-based paint with oil-based paint or mix different types of paint to avoid different adverse effects and reactions. Claim without the company's consent The company will not assume all responsibilities.
6. The anti fingerprint agent for glass manufacturers believes that when baking, observe whether the temperature is correct, and the self-drying type should also pay attention to whether the environment is clean and free from dust.